I've been using my FCB with Guitar Rig since GR2, so I do know of what I speak. I have NOT upgraded to GR6 from GR5, but they didn't change anything significant, just added a couple of new amps shot

You want the UNO Chip. Whether you want the Original UNO or UNO2 depends on your needs and your programming skills. With the stock chip you can program the switches to Toggle, but the LEDs WILL NOT

Hi Geoff, Following the messages here for quite a while, never heard anyone combining Guitar Rig 6 and FCB 1010. I have no answer to your problem but if I may, can I ask you this: Were you used to the

This is most likely a problem with too much running on the computer/ipad. If you have a lot of effects running at the same time, or too many background processes, the audio system can bog down and

Hi all, I’m getting a cracking/popping noise when I turn an effect on/off in Guitar Rig 6 while using the FCB1010 midi controller. Any ideas what could be causing this & how to to possibly fix

Just got pedal for xmas, want it to act as multi pedalboard. On/off for bottom row. I can program expressions fine. Want each pedal with light on for on and same with off. Like the rp1 or rp100 from

Nooo, how couldn't i can see that before, thanks:)

Your first 3 presets are sending the OFF message on Preset Load. 4 and 5 are sending NO CHANGE. If it's OFF it'll stay OFF and vice versa.

Ok, my bad, i wondering which one is better:)

Having the actual sysex (.lgp) is much more helpful than a text file.

Hello, i have weird problem with that FX unit and FCB, FCB's button 10 is sending cc88 and that is toggling tuner on/off, so far everything is fine. But when using FCB's lower buttons to changing

Sounds like your Overdrive control is a Toggle - it turns on the first time it gets the trigger, then off the next. I'm guessing you start with it off (always a good idea for MIDI controlled

Hello all, and thanks for allowing me to join the group. I have managed to get my fcb1010 to work with Revalver 4, within Reaper with a stock chip. However, when I playback what I have recorded, I

Think of it as a marriage between three: your layout of buttons that works well for how/what you play (this is largely a human thing, how well do you remember what button does what, is the layout

Welcome to the group! I've never used BeatBuddy, so can't give you much in the way of specific advice, but the general answer is, "if you can do it by MIDI, you can do it with the FCB1010" Looking at

Hi all, this is my first post so I appreciate your understanding. Here is what I am looking to be able to do. I perform as a guitarist and lead singer at small events that have long dance sets. The

I have succeeded in programing all the Bank 0 locations to be Notes, and have started to "learn" SooperLooper to respond. To other beginners: The manual for this is confusing and poorly written and

That sounds very confusing to me, if with "the pedal" you mean the FCB1010. The original poster has an FCB1010 equipped with FCB-505 firmware. This means the FCB1010 does not need to be programmed,

Fonziemsun - I do not know anything about the RC-500, and I do not know what you mean by "the chip", however I can see that you may not understand the reply from ossandust . Don't expect the FCB1010

Glad you got it sorted. Rock On!