I have one. Only thing is all I have to do is turn around and push the tuner button on the amp to access the tuner.

As an alternative I left the FCB1010 in factory reset and made all my changes in the Cyber Twin itself which was easier for me since I understand the amp better than the pedal. Patch numbers are off b

You are welcome, have fun in the depths of the Cyber Twin's possibilities, Bruce

The trim control on the input limits the input signal so clipping can occur. Send return effects can be not so good too I have found, Bruce

Copied and pasted this for you David: How to use the pedal and amp together: No problem. Restore the FCB 1010 to factory preset. Using the Cyber Twin utility button I found Cont Controller and set it

Hi, yes I have found the same thing. I put a boss flanger in the effects send return and it didn't do anything! I could hear the whoosh of the flange but it didn't effect the guitar. I hung a label on

I do, i found it easier to make the required changes in the utility menu of the C T than to try to change the FCB1010 to fit the CT. My FCB1010 is factory preset.

Hope you can be there! All the details are on the poster. Happy December to you! Bruce

http://youtu.be/7dCeubK1U68 Please share this if you liked it! best wishes, Bruce

hi all , here's the link: http://www.avaaz.org/en/save_the_southern_ocean_5/?tPRgWbb

I have a Cyber Twin too. Just go into midi on the cyber twin and there is a midi map option. change the location by one on each patch and you are there. should take about 5 minutes max. Bruce

Maybe you need to go back to factory settings on both the amp and the pedal and start over? I know you hate to lose what you've alredy programmed but you are probably an expert by now anyway.

I use the Cyber Twin and the FCB1010. I left the FCB at factory settings and made my changes in the CT. Under utility I set Cont controller at 27. Pedal B is master volume and pedal A is the Cont cont

Thanks again! I just got around to implementing your instructions and it works like a charm. I had left the C T amp for a while after it went berserk on me at a gig last Hallowe'en. Started making swe

Thank you, thank you! I look forward to trying it! I'll let you know how it works out. haven't been using the Cyber Twin much lately because it went haywire on me at a gig (maybe because I had wired a

Please let me know if it is possible Jason, and how you did it. I would greatly appreciate it since I have the exact same rig as you. I never set up a tempo switch because I though I would have to do

---------- Forwarded message ---------- From: Luis Morago - Avaaz.org <avaaz@...> Date: Wed, Nov 16, 2011 at 1:35 AM Subject: The end of YouTube To: "brucenasmith@..." <brucenasmith@gmail.

No problem. Using the Cyber Twin utility button I found Cont Controller and set it to 27 (this is the FCB1010 left pedal). Then I adjusted the midi#: map so that 0 Preset: 01, 1 Preset: 02, 02 Preset:

I left the FCB1010 as it was from the factory and made some very simple reversable changes in the cyber twin.

I use the same rig, I made all the changes in the Cyber Twin under utility and left the FCB1010 in factory mode. I believe I just did trial and error with the expression pedal control number in the C