Re: FCB1010 Uno with Amplitube


EJ SHELDON
 

First, get the UNO_ControlCenter Editor:


Read the manual.

Then, open the attached .lgp (ControlCenter sysex) file and download it to your FCB/UNO board.

If you're using Amplitube in standalone mode, you'll want to set the Receive Channel in Amplitube to Channel 1.

This sysex is configured with the STOMP pedals on the bottom row.

Click MIDI (lower right on AT (Amplitube) UI, Click Control Change then Global.
If you're in Bank 00, hit the DOWN pedal once to go to Bank 18.
Highlight PRESET NEXT. Click LEARN. Press Pedal 10.
Highlight PRESET PREVIOUS. Click LEARN. Press Pedal 9.
Highlight VOLUME. Click LEARN. Operate LEFT EXPRESSION PEDAL.
Highlight WAH. Click LEARN. Operate RIGHT EXPRESSION PEDAL.
Highlight WHARMONATOR. Click LEARN. Operate RIGHT EXPRESSION PEDAL.
*NOTE - Typically, you won't have WAH and WHARMONATOR on the same preset.
Highlight TUNER. Click LEARN. Press Pedal 8.

Press UP pedal to return to Bank 00.

Highlight Stomp A Slot 1 Bypass. Click Learn. Press Pedal 1.
Highlight Stomp A Slot 2 Bypass. Click Learn. Press Pedal 2.
Highlight Stomp A Slot 3 Bypass. Click Learn. Press Pedal 3.
Highlight Stomp A Slot 4 Bypass. Click Learn. Press Pedal 4.
Highlight Stomp A Slot 5 Bypass. Click Learn. Press Pedal 5.

Done!

NOTE: The CC#s I'm using are taken from the non-reserved segment of CC#s as specified in the MIDI spec.

Advice: Create a folder called MY PRESETS or something like that. When creating new presets or modifying Factory Presets, always save them to this folder. This way, all your Factory Presets and folders remain pristine.

In order to call Presets, you need to load them into the MIDI/Program Change.panel.

Have Fun!



.

Join uno@fcb1010.groups.io to automatically receive all group messages.