Yep, that does suck, sorry. No way I know to get around it, but the shipping would probably drive the cost up the same as the other good ones you can get without international shipping.

Nice..; However "USA and Canada Only".... How to do for the 228 others counrty :) ??

The second batch of CME's new MIDI DIN to USB cable, the U2MIDI, just went on sale, and I jumped on it (Normally $20, use code WM30 to get it for $14!!). Anyone lucky enough to get one from the first

To newbies and wise ones: Greetings! I've enjoyed using the UNO2 Chip. Below is a brief summary of my experience. I hope it helps fellow newbies like me. It was a challenge to program my FCB1010

Many thanks. :)

On Sat, Jan 14, 2023 at 07:38 PM, Moff40 wrote: Could you reset it for me please?Done.

Xavier: During this process, I pulled my licensed UnO2 and installed the UnO1. Affer the experiment, I reinstalled the UnO2, it wants to be licensed again, but I get “You have already used your

On Fri, Jan 13, 2023 at 02:59 AM, ossandust wrote: I wouldn't call it a problem with the Kemper, but it IS the behavior of the Kemper. Selecting a rig will also modify the effect states the way you

On Fri, Jan 13, 2023 at 10:08 AM, Moff40 wrote: I think there was a whole lot of misunderstanding and miscommunication during this thread. I did confirm that UnO1 didn’t preserve the effects

I think there was a whole lot of misunderstanding and miscommunication during this thread. I did confirm that UnO1 didn’t preserve the effects between patches either. I’ve used the FCB with so

On Fri, Jan 13, 2023 at 02:46 AM, Moff40 wrote: If the “no change” option isn’t chosen, it will display the same behaviour as is happening now, ie, LEDs stay on, but effects switch off. That is

On Fri, Jan 13, 2023 at 12:50 AM, Moff40 wrote:Correct. I wouldn't call it a problem with the Kemper, but it IS the behavior of the Kemper. Selecting a rig will also modify the effect states the way

On Thu, Jan 12, 2023 at 10:22 PM, Moff40 wrote: I am talking about stomps, and am most certainly NOT trying to use expression pedals to control effect on/off, other than Tipswitch commands to enable

Thanks, for the update! That confirms what my thinking was.

I am talking about stomps, and am most certainly NOT trying to use expression pedals to control effect on/off, other than Tipswitch commands to enable Wah and Whammy, but that’s it. Do you not see

I'm not sure who it is that you're not being argumentative with. I'm not even sure that we're talking about the same thing. The sample code you included is all about Expression pedals. I THOUGHT you

Hey all, been struggling trying to get the A & B expression pedals to work in Studio One 6 which I just recently upgraded to. Can map whatever else but those 2!!! Firmware UNO 1.0.4 is what I'm

Not being argumentative, but with the previous UnO1 installed, and the “No Change” option selected in ControlCentre, the effects remain on even after a Program Change. If the “no change”

My guess is that when you send a program change to your device, Uno2 is not changing the effect but the device itself has defined a different effect for that particular program change. Maybe if you

A Stomp will stay ON between FCB preset changes, but it will not SEND again unless you use SwitchOn in the new preset. IOW - Stomp1 = OD Stomp2 = phaser Stomp3 = Delay The preset can send: Preset 2